Types of cables:

´  Un-shielded Twisted Pair (UTP) Cable

´  Shielded Twisted Pair (STP) Cable

´  Coaxial Cable

´  Fiber Optic Cable

Twisted pair:

two varieties:

´   shielded and unshielded.

´  The quality of UTP may vary from telephone-grade wire to extremely high-speed cable.

´  The cable has four pairs of wires inside the jacket.

´  Each pair is twisted with a different number of twists per inch to help eliminate interference from adjacent pairs and other electrical devices.

´   The tighter the twisting, the higher the supported transmission rate and the greater the cost per foot.

´  The EIA/TIA (Electronic Industry Association/Telecommunication Industry Association) has established standards of UTP and rated six categories of wire (additional categories are emerging).

´  Unshielded Twisted Pair Connector

´  The standard connector for unshielded twisted pair cabling is an RJ-45 connector.

´   This is a plastic connector that looks like a large telephone-style connector.

´  A slot allows the RJ-45 to be inserted only one way.

´   RJ stands for Registered Jack, implying that the connector follows a standard borrowed from the telephone industry.

´  This standard designates which wire goes with each pin inside the connector.

Shielded Twisted Pair (STP) Cable:

´  Although UTP cable is the least expensive cable, it may be susceptible to radio and electrical frequency interference .

´  If you must place cable in environments with lots of potential interference, or if you must place cable in extremely sensitive environments that may be susceptible to the electrical current in the UTP, shielded twisted pair may be the solution.

´   Shielded cables can also help to extend the maximum distance of the cables.

´  Shielded twisted pair cable is available in three different configurations:

1. Each pair of wires is individually shielded with foil.
2. There is a foil or braid shield inside the jacket covering all wires (as a group).
3. There is a shield around each individual pair, as well as around the entire group of wires (referred to as double shield twisted pair).

Coaxial Cable:

´  Coaxial cabling has a single copper conductor at its center.

´   A plastic layer provides insulation between the center conductor and a braided metal shield .

´  The metal shield helps to block any outside interference from fluorescent lights, motors, and other computers.

´  Although coaxial cabling is difficult to install, it is highly resistant to signal interference.

´  In addition, it can support greater cable lengths between network devices than twisted pair cable.

´   The two types of coaxial cabling are thick coaxial and thin coaxial.

´  Thin coaxial cable is also referred to as thinnet. 10Base2 refers to the specifications for thin coaxial cable carrying Ethernet signals.

´   The 2 refers to the approximate maximum segment length being 200 meters. In actual fact the maximum segment length is 185 meters. Thin coaxial cable has been popular in school networks, especially linear bus networks.

´  Thick coaxial cable is also referred to as thicknet.

´   10Base5 refers to the specifications for thick coaxial cable carrying Ethernet signals.

´  The 5 refers to the maximum segment length being 500 meters.

´   Thick coaxial cable has an extra protective plastic cover that helps keep moisture away from the center conductor.

´  This makes thick coaxial a great choice when running longer lengths in a linear bus network.

´  One disadvantage of thick coaxial is that it does not bend easily and is difficult to install.

Fiber Optic Cable:

´  Fiber optic cabling consists of a center glass core surrounded by several layers of protective materials.

´  It transmits light rather than electronic signals eliminating the problem of electrical interference.

´  This makes it ideal for certain environments that contain a large amount of electrical interference.

´   It has also made it the standard for connecting networks between buildings, due to its immunity to the effects of moisture and lighting.

´  Fiber optic cable has the ability to transmit signals over much longer distances than coaxial and twisted pair.

´  It also has the capability to carry information at vastly greater speeds.

´  This capacity broadens communication possibilities to include services such as video conferencing and interactive services.

´  The cost of fiber optic cabling is comparable to copper cabling; however, it is more difficult to install and modify.

´  10BaseF refers to the specifications for fiber optic cable carrying Ethernet signals.

´  The center core of fiber cables is made from glass or plastic fibers .

´   A plastic coating then cushions the fiber center, and kevlar fibers help to strengthen the cables and prevent breakage.

´   The outer insulating jacket made of teflon or PVC

´  There are two common types of fiber cables -- single mode and multimode.

´  Multi-mode cable has a larger diameter; however, both cables provide high bandwidth at high speeds.

´  Single mode can provide more distance, but it is more expensive.